next »

[Kerry Verne]

I copied it off the web into an Excel doc for referencing my drill bits. Perhaps someone else might find it useful.

Kerry

[Phil Tomlinson]

Thanks Kerry,

Funny I just did my own spreadsheet the other day because I put one of those Wixey Digital readouts on my table saw and I just can't remember the decimal equivalent for 7/32"!

[Kerry Verne]

I lucked out and found a laminated card that covered conversion up to 1/2", which is great for the drill press. (Now stuck via magnet to it.) I ought to find a way to laminate this one too.

[Scott Peterson]

Thanks for the spreadsheet!  Engineers love spreadsheets - even more than pocket protectors...    I had a similar one but without the milimeters...yours is a good one!

I laminate cards at Kinkos - they have an assortment of sleeves and it will cost you a whole $2 to laminate a legal size page.  The other option I use is a clear plastic sleeve that fits into a 3-ring binder (any office store, WalMart, Target, etc).  I use these for cheat sheets with equations and data for work and found these work pretty well in the shop too...